storedge 3310 and format
hi,
i have the following problem:
a storedge 3310 with raid controller. i have partitioned the volume ( which consists of 6 raid 1 logical drives) into 4 partions and assigned luns to these partitions.
probe-scsi-all shows the following:
/pci@1e,600000/pci@2/scsi@4
Target 0
Unit 0 Disk SUN StorEdge 3310 0325
Unit 1 Disk SUN StorEdge 3310 0325
Unit 2 Disk SUN StorEdge 3310 0325
Unit 3 Disk SUN StorEdge 3310 0325
format shows only the first one:
0. c0t0d0
/pci@1c,600000/scsi@2/sd@0,0
1. c0t1d0
/pci@1c,600000/scsi@2/sd@1,0
2. c2t0d0
/pci@1e,600000/pci@2/scsi@4/sd@0,0
where are the other three partitions?
[724 byte] By [
oheydorn] at [2007-11-13]

Hi there,
I have a similar situation where I set up a SE 3310 connected to a Sunfire V210 running Solaris 10 GA.
The SE 3310 was set up as 2 RAID 5 logical volumes, each
with 5x72GB disk drives. I also map the hosts LUNS etc...
At the V210, when I did the probe-scsi-all it sees both RAID5
logical disks as StorEdge 3310 0325 (firmware 3.25)
however when I boot up with the -rv option, it only sees one
RAID5. Where is the other RAID 5 logical drive?
I did update_drv -f sd, devfsadm; manually edit the sd.conf
to add additional controllers and LUN's (c0,c1,c2 and up to
32 LUN's for each controller, but I still do not see the other
RAID5 logical drive. Where is it?
Please help !!!
Tony